Also make sure the interface and emulation device is selected to AutoProm, once that is selected you can go ahead and hit ok. Program Chip – This will perform the action of programming the chip. This reads the chip into the local buffer. Failing blank checks is a common sign of fake chips. The Size of the burner is astonishing, and it comes with its own usb cable which is about 4ft long.
|Date Added:||19 February 2008|
|File Size:||7.1 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
You asked, we deliver! If this test passes, you can be confident that the chip was programmed correctly.
You need to make sure the program you put in the chip ends up in the top end of the chip, so these settings matter. He walked me through all these steps as I wrote for you.
Note – All addresses and filesizes must be 64 byte aligned. These settings are important because most of mostes chips used in ECUs are a smaller capacity than the chip you are programming.
The chip gets read into the buffer, then the buffer gets saved wnd file.
Flash & Burn Program for BURN1/2/Jaybird+APU1
It reads the chip contents from the specified “Chip Addressing” fields and places them at the beginning of the buffer. Double check addressing settings. I opened moahes box to find everything Bubbled wrapped to perfection. Switching adapters which hold multiple programs require the use of offsets to fit multiple programs on moatrs single chip for a switching adapter. Load File To Buffer – Pressing this button will bring up an expolorer dialog to select a file with which to fill the buffer.
This reads the chip into the local buffer. Similarly, reading a chip to a file is done by way of the buffer. Get out your burner and a chip. Also, input the address within the chip that you’d like that portion of the buffer moate be programmed to. Switching adapters use chips that are larger than an ECU requires, allowing the extra space to be used for multiple programs. Burning a file to a chip requires that this buffer be filled with the file. Programming chips with offsets comes into play in two situations:.
Make sure it says device enable, then click port settings tab, then click the advanced button located in the middle.
Beginners: Programming Chips « Moates Support
Must program using EEC Editor. Erase Sector F only – This will moxtes an individual 64kbyte sector of a 29F Some adapters have chips which can hold more tunes than there are address lines for switching. Read Chip – This will perform the action of reading the chip. Chip Offsets With a Single Tune: Go to control panel and open the system icon. Save Buffer To File – This button will allow you to save the contents of the buffer to a file.
It should be noted that this will erase the entire chip.
Don’t put it in backwards! While the correct values are often selected, you can manually enter them. If instead you see something like this: Take note of the file size indicated in the message window.
Once you do have it on a COM supported, go back to the port setting tab and then select the Bits Per Second tab and change it from to then hit okay this is optional. One cable needed and it’s included in the bundle. Once you download and install this program, I suggest you restart your machine before proceeding.