The value of 0 indicates that timeout is disabled default. Generally, the values are sent in the same form in which they would be issued by the DTE in a parameter setting command; if multiple values are supported, they will generally be separated by commas, as in a parameter setting command. Dial tone detection is disabled, and busy detection is enabled. In the case of a dialing or answering command, the modem switches from command state to online data state, and issues a CONNECT result code. After the30 days of the warranty period the customer will only receive an in-store credit.
|Date Added:||23 November 2010|
|File Size:||19.92 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Read-only parameters may be read and tested.
AOPEN FMH PCI K56FLEX/V FAX/MODEM
The maximum qopen allowed between receipt of the last character of the three escape character sequence from the DTE and sending of the OK result code to the DTE is controlled by the S12 register.
P Select pulse dialing: Windows will detect the modem. Returns the higher order byte of the EQM value. If the DOA is not valid and the customer still wants a credit they will be responsible for any shipping charges accrued aaopen behalf of Sunsetmicro. Restart the computer after plugging in the modem. This command may not be available for some countries due to PTT restrictions.
The square brackets are not used when the words appear in the command line. A cash refund is only given to the customer if xopen the first 30 days of the warranty period.
The result codes that the modem can send are described below. Other characters that appear in syntax descriptions must as included as shown. The modem determines the calling type and issues DATA result code 13 if the caller is a data modem or issues FAX result code apen if the caller is a fax modem.
Solvusoft: Microsoft Gold Certified Company
To enter a command line, type: The definition of the result code specifies whether or not values are appended to the result code, and, if so, how many, their types, and their assumed default values if omitted.
The value of 0 indicates that timeout is disabled default. An available PCI slot in the personal computer. This device must accept any interference that may cause undesired operation. To read values from more than one S-Register, type: The Fed Ex office is about a mile away and we do use them for late shipping air orders.
To be certain of the number of devices you may connect to your line, as determined by the REN, you should contact your local telephone company to determine the maximum REN for your calling area.
The equipment may not be used on coin service by the telephone company. There are three flow control mode: The format of the response is shown by the example below.
The list is preceded by a left parenthesisand is followed by a right parenthesis. A section on diagnostics using loopback test is also included to help you isolate problems that may occur anywhere from the computer interface to the modem at the remote site.
If no more data is received before 5 seconds elapse, the modem drops carrier, goes on-hook, and generates the ERROR result code. We recommend our installer which is a driver system utility for scanning, matching, downloading, and installing verified drivers.
The modem disconnects from the line. A single character is sufficient to abort akpen command in progress; however, characters transmitted during the first milliseconds after transmission of the termination character wopen ignored to allow for the DTE to append additional control characters such as line feed after the command line termination character.
The character format is 8 bits data, no parity, and 1 stop bit. Otherwise, the default is the expected country of sale or first installation. W Wait for dial tone: A command line may be repeated multiple times in this manner. The modem then returns to command mode. Press the STOP button and say “yes”, you do want to stop the driver.